1. Quick Release Helmet Hardware
This is a unique two finger quick eject helmet attachment system.
2. Emergency Pull
Optional rubber pull tag for quick disconnect.
3. Wings
Unit can accept 2” or 3” seat belts. The wings also keep the belts in place under impact or loose belt conditions.
4. Flexible Bar
This allows for upper body movement and comfort while driving. Also allows user to flex the unit over larger necks.
5. Belt Guides
The guides keep the unit centered on the driver at all times, not allowing the unit to slip from under the belts.
6. Body Forming Pads
The body forming Kevlar pads fit under the seat belt, therefore taking any pressure off the collar bone and making the unit very comfortable.
7. Adjustable Rear
The unit is adjustable to fit most seat angles from 10°-40°. This also allows the driver to adjust the back of the unit for comfort on interference with the helmet or the seat.
8. Low Rear The low profile design allows easy access from confined areas with no interferance on roll bars in dragsters and landspeed cars.
9. Tension Neutralizing Tether
Using a single, adjustable tension neutralizing tether, the loads under impact are distributed through four different load paths. This unique system offers an equal distribution of forces under impact. This system also offers a full range of head motion and side and angular impact protection.

Made in the USA
The NecksGen unit is designed and made in the USA, using the latest carbon fiber composite Dupont material. Not only are these materials lightweight, but they are extremely strong.


-SFI 38.1 Approved
-One size (fits most)
-4 adjustable angles (10-40°)
-Low rear for helmet & roll bar clearance
-Can accept 2” or 3” seat belts
-Wings keep belts in place
-Belt guides keep unit centered
-Body forming pads
-Flexible & comfortable
-Quick release helmet hardware
-One adjustable tension
-neutralizing tether
-Full range of head motion
-Offers front and side impact protection